1. Open: Remove the cap from the brush, pull off the case, remove and discard the rubber band. Put the cap back on.

2. Activate: Tap the bottom of the case on a hard surface several times, then check if the powder is on the brush. Run your finger over the brush several times. Using small circular movements with little pressure, run the brush over the outside of your palm. If necessary, repeat the movements until you notice that the powder is evenly distributed with the brush. Repeat the activation procedure before and during each use so that the powder is evenly distributed.

3. Apply: Apply the powder evenly to clean skin or makeup in circular motions. Make sure all areas of the skin are covered with powder. If you apply Sunforgettable® powder after a moisturizer, primer or liquid foundation, make sure the previous product is completely absorbed by the skin before applying the powder. Reapply the powder every two hours to ensure long-lasting protection.

Active Folders:
Titanium Dioxide 22.5%; Zinc Oxide 22.5%

Aqua/Water, Hydrogenated Polyisobutene, Cyclopentasiloxane, Caprylic/Capric Triglyceride, Lauryl Polyglyceryl-3 Polydimethylsiloxyethyl Dimethicone, Glycerin, Panthenol, Mica, Dimethicone Crosspolymer, Albizia Julibrissin Bark Extract, Sea Water, Sorbitol, Jojoba Esters, Sodium Hyaluronate, Palmitoyl Tripeptide-5 , Tremella Fuciformis Sporocarp Extract, Hydrolyzed Algin, Ascophyllum Nodosum Extract, Betaine, Dunaliella Salina Extract, Asparagopsis Armata Extract, Sucrose, Darutoside, Pantolactone, Tocopherol, Sodium Chloride, Dimethicone/Vinyl Dimethicone Crosspolymer, Silica, Polyhydroxystearic Acid, Glyceryl Behenate/Eicosadioate, Dimethicone, Lauroyl Lysine, Dimethiconol, Ethylhexylglycerin, Triethoxycaprylylsilane, Alumina, Phenoxyethanol, Potassium Sorbate, Sodium Benzoate, Citric Acid, Iron Oxides (CI 77491, CI 77492, CI 77499)